Announcement

Collapse
No announcement yet.

Encoders not working

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Encoders not working

    Hi,

    I followed Bruce Schafer's youtube video on youtube for encoders. I have 4 motors in our robot for moving right or left or forward. The program doesn't work and gives and error about the block. I don't exactly know the error right now. These are my blocks. Can anyone see if it has any errors?
    https://goo.gl/photos/K4fpLVVBXZg3KZox7
    Thanks,
    Programmer - FTC Delta Kappa

  • #2
    Hi Ali

    What error messages are you getting when you run the op mode?

    Tom

    Comment


    • #3
      Originally posted by Tom Eng View Post
      Hi Ali

      What error messages are you getting when you run the op mode?

      Tom
      Yeah, right now I exactly don't remember the error. I will post it tomorrow as soon as we start to meet for robotics. But I have given the picture of my program. There might be a problem in it.
      Thanks,
      Programmer - FTC Delta Kappa

      Comment


      • #4
        I tried it but now i cannot even initialize it. When I click on to start when comes back to initialize. So basically I cannot start the program.
        Thanks,
        Programmer - FTC Delta Kappa

        Comment


        • #5
          Originally posted by bassamali01 View Post
          I tried it but now i cannot even initialize it. When I click on to start when comes back to initialize. So basically I cannot start the program.
          I am sorry for being late but now the encoder program is just moving forward and then gives an error.
          https://goo.gl/photos/yAA11PgouYKDc4V7A
          Thanks,
          Programmer - FTC Delta Kappa

          Comment

          Working...
          X