Cannot change hub address!

[[Wolvineers] Sparklester]

Our robot controller phone detects the REV Expansion Hub in the settings with the address 0 assigned to it. Changing it to any other value gives an "address succesfully changed" message, but no linking is made and going back to that tab will show that the address is still 0.

[Tom Eng]

Hi Sparklester - could you check with REV's tech support to see what they recommend? I am not sure if the address value should be 0. I wonder if it's a factory hardware config issue.

[[Wolvineers] Sparklester]

Hi Sparklester - could you check with REV's tech support to see what they recommend? I am not sure if the address value should be 0. I wonder if it's a factory hardware config issue.

Alright, will do that. I'll update as soon I find anything.