Announcement

Collapse
No announcement yet.

Rev Robotics Hub Stopped Working

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Rev Robotics Hub Stopped Working

    My team and I were driving our robot and the rev expansion hub stopped working. The lights are not turning on and the phone says its unable to open the expansion hub. Any help would be appreciated

  • #2
    The other day, we had the solder joint of the REV switch break. It was the red wire near the connection of the REV unit. It was difficult to see, as it was under the heat shrink at the connection.
    You might want to check resistance of switch in closed position.

    Comment


    • #3
      If you aren't able to figure out the problem after some basic trouble shooting, you can email support@revrobotics.com for more help.

      -Rachel from REV

      Comment


      • #4
        I would like to chime in here that the several times I contacted REV Robotics support, they have always been very helpful and my problems got resolved reasonably quickly. They have done a good job with supporting their products including sending out replacements when needed.

        Comment

        Working...
        X